My new goal is to make a good frame for FPV-flying, so it has be laid out properly where everything goes on it. I intend on putting a GoPro 3 on it to capture some sweet aerial footage. SO with what I had learned from my earlier projects I decided to make a mock up first in 3d of the frame and I came up with something like this.
The idea with the weird shape of the center plates is to make it oblong shaped so I have actually some space where to put the flight controller, RX, VTX and the GoPro. The center area with the hole will be taken mostly with the flight controller. The center plate is not big, it's only 10 cm across on the thinnest part and 15 cm the long way.
Sunday, June 29, 2014
Saturday, June 28, 2014
This is one of my active projects at the moment. I started it around december of 2013 after reading an awesome article on hackaday.com about a DIY light controller. I designed my own boards on the same month and ordered them from IteadStudio and made a parts list and ordered them from Digikey. We'll continue this story later in the post.
It's a lighting controller for RGB-leds to be used with DMX lights software like Freestyler or with christmas lighting software like Vixen 3. This project was based on Shelby Merrick's original project* for the same thing, but I did some changes here and there. For example, Shelby's original Floodbrain board was 18-channel controller, which you could use to control 6 RGB-leds, but mine has 24 channels, which is good for 8 RGB-leds.
(*Link to Shelby Merrick's original controller project)
|First populated prototype version pcb|